1994 CADILLAC FLEETWOOD for sale | LemonFree.com

5 May 2015 | Author: | Comments Off on 1994 CADILLAC FLEETWOOD for sale | LemonFree.com

Refine Your Search

Lemon Free has found some important recall information regarding 1994 Cadillac Fleetwood vehicles

Campaign Number: 96V019000

Component Name: SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT

Manufacturer: General Motors LLC

Description: DEFECTIVE LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS WERE NOT PROPERLY TORQUED AND CAN LOOSEN.

Defect: IF THE LOWER CONTROL ARM BALL JOINT LOOSENS, FATIGUES AND SEPARATES FROM THE FRONT SUSPENSION KNUCKLE, IT COULD CAUSE LOSS OF VEHICLE CONTROL.

Corrective Action: DEALERS WILL INSPECT BOTH FRONT LOWER CONTROL ARM BALL JOINT ATTACHMENT NUTS FOR PROPER TORQUE. IF THE BALL JOINT HAS LOOSENED FROM THE KNUCKLE, BOTH THE BALL JOINT AND THE KNUCKLE WILL BE REPLACED.

Campaign Number: 95V082000

Component Name: VEHICLE SPEED CONTROL:SPRINGS

Manufacturer: General Motors LLC

Description: THESE VEHICLES FAIL TO CONFORM TO FMVSS NO. 124, ACCELERATOR CONTROL SYSTEMS. AT LOW TEMPERATURES, EXCESSIVE FRICTION CAN OCCUR IN THE ACCELERATOR PEDAL ASSEMBLY.

Defect: CONSEQUENCE OF NON-COMPLIANCE: IN THE EVENT OF A FAILURE OF THE TROTTLE RETURN SPRING, IF THERE IS EXCESSIVE FRICTION IN THE PEDAL ASSEMBLY, THE ENGINE SPEED MAY NOT RETURN TO IDLE INCREASING THE POTENTIAL FOR A VEHICLE CRASH.

Corrective Action: DEALERS WILL REPLACE THE ACCELERATOR PEDAL ASSEMBLY.

Campaign Number: 94V210000

Component Name: FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:MOUNTING

Manufacturer: General Motors LLC

Description: THE FUEL TANK ATTACHMENT STRAP FASTENERS WERE NOT PROPERLY TIGHTENED. THE FASTENERS CAN COMPLETELY DETACH, EVENTUALLY ALLOWING THE FUEL TANK TO SAG AND THE BOTTOM OF THE TANK TO STRIKE THE ROADWAY.

Defect: THIS CAN RESULT IN A FUEL TANK LEAK AND FIRE IF THE LEAKING FUEL IS EXPOSED TO A SOURCE OF IGNITION.

Corrective Action: DEALERS WILL RETIGHTEN THE FUEL TANK STRAP FASTENERS.

Campaign Number: 94V076000

Component Name: WHEELS:LUGS/NUTS/BOLTS

Manufacturer: General Motors LLC

Description: PAINT ON THE WHEEL MOUNTING SURFACES CAN ACT AS A SHIM BETWEEN THE WHEEL AND THE ROTOR/DRUM. AS THE VEHICLE IS DRIVEN, THE WHEEL IMBEDS INTO THE PAINT, LOOSENING THE LUG NUT AND CAUSING A LOSS OF CLAMP LOAD.

Defect: ONCE CLAMP LOAD IS LOST, ALL TIRE LOADS ARE TAKEN BY THE WHEEL STUDS RESULTING IN A FRACTURE OF THE WHEEL STUDS. THIS COULD CAUSE THE WHEEL TO SEPARATE FROM THE VEHICLE AND COULD RESULT IN A VEHICLES CRASH WITHOUT PRIOR WARNING.

Corrective Action: DEALERS WILL CLEAN THE WHEEL MOUNTING SURFACES FOR ALL FOUR WHEELS. ALSO, THE WHEEL STUDS WILL BE INSPECTED FOR DAMAGE AND WILL BE REPLACED AS NECESSARY.

Campaign Number: 94V049000

Component Name: ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSE

Manufacturer: General Motors LLC

Description: THE ENGINE OIL COOLER INLET HOSE MAY HAVE BEEN INSTALLED TOO CLOSE TO THE STEERING GEAR CAUSING CHAFING. THE CHAFING CAN EVENTUALLY WEAR THROUGH THE HOSE’S PROTECTIVE SLEEVE RESULTING IN ENGINE OIL LEAKING ONTO THE ENGINE.

Defect: IF THIS OCCURS, THE OIL LEAK ONTO THE ENGINE CAN RESULT IN AN ENGINE COMPARTMENT FIRE.

Corrective Action:

Tagged as:

Other articles of the category "Cadillac":

Twitter-news
Our partners
Follow us
Contact us
Our contacts

dima911@gmail.com

Born in the USSR

423360519

About this site

For all questions about advertising, please contact listed on the site.


Car Catalog with specifications, pictures, ratings, reviews and discusssions about cars